Erratum to: The 2016 Thermal Spray Roadmap (Journal of Thermal Spray Technology, (2016), 25, 8, (1376-1440), 10.1007/s11666-016-0473-x)
Vardelle, A. and Moreau, C. and Akedo, J. and Ashrafizadeh, H. and Berndt, C.C. and Berghaus, J.O. and Boulos, M. and Brogan, J. and Bourtsalas, A.C. and Dolatabadi, A. and Dorfman, M. and Eden, T.J. and Fauchais, P. and Fisher, G. and Gaertner, F. and Gindrat, M. and Henne, R. and Hyland, M. and Irissou, E. and Jodoin, B. and Jordan, E.H. and Khor, K.A. and Killinger, A. and Lau, Y.-C. and Li, C.-J. and Li, L. and Longtin, J. and Markocsan, N. and Masset, P.J. and Matejicek, J. and Mauer, G. and McDonald, A. and Mostaghimi, J. and Sampath, S. and Schiller, G. and Shinoda, K. and Smith, M.F. and Syed, A.A. and Themelis, N.J. and Toma, F.-L. and Trelles, J.P. and Vassen, R. and Vuoristo, P.
JOURNAL OF THERMAL SPRAY TECHNOLOGY
Volume: 26 Pages: 985-986
We regret that the original article contained the following errors and omissions: • The following author was not listed: Bertrand Jodoin, Department of Mechanical Engineering, University of Ottawa, Ottawa, ON, Canada. • The caption for Fig. 2 on page 1378 should read, “Fig. 2 Cross section of single impacts of cold-sprayed Ti-6Al-4V particles on titanium substrate. Example demonstrates that metallurgical bonding by ASI occurs in the particle substrate interfaces providing higher strength as compared to the substrate material.” • The caption for Fig. 6 on page 1382 should read, “Fig. 6 Application roadmap of AD method.” Errors in Figure and Table Numbering • On page 1380, section 2.2.4 should read, “Medical applications such as ceramic coatings for dentures and artificial bones have also been studied (Ref 27) (Fig. 6).” It was incorrectly listed as “Fig. 7.” • On page 1381, section 2.2.5 should read, “As shown in Fig. 4, clear lattice images with crystal grains sized less than 10 nm across were observed.” It was incorrectly listed as “Fig. 1.” • On page 1383 in the first paragraph, the fifth sentence should read, “This method is envisaged to variably change the deposition principle by introducing the thermal effect of the conventional thermal spray process to the AD method such that the HAD method benefits from both of these complimentary technologies (Fig. 7).” It was incorrectly listed as “Fig. 4.” • On page 1402, section 3.3.1, in the second paragraph, the seventh sentence should read, “The different types or modes of wear are shown in Fig. 23.” It was incorrectly listed as “Fig. 1.” • On page 1422, at the end of the first paragraph, the text should read, “Table 2 summarizes the key applications and components where thermal spray technology is being used.” It was incorrectly printed as “Table 1.”. © 2016, ASM International.