Optically excited structural transition in atomic wires on surfaces at the quantum limit
Frigge, T. and Hafke, B. and Witte, T. and Krenzer, B. and Streubühr, C. and Samad Syed, A. and Mikšić Trontl, V. and Avigo, I. and Zhou, P. and Ligges, M. and Von Der Linde, D. and Bovensiepen, U. and Horn-Von Hoegen, M. and Wippermann, S. and Lücke, A. and Sanna, S. and Gerstmann, U. and Schmidt, W.G.
Volume: 544 Pages: 207-211
Transient control over the atomic potential-energy landscapes of solids could lead to new states of matter and to quantum control of nuclear motion on the timescale of lattice vibrations. Recently developed ultrafast time-resolved diffraction techniques combine ultrafast temporal manipulation with atomic-scale spatial resolution and femtosecond temporal resolution. These advances have enabled investigations of photo-induced structural changes in bulk solids that often occur on timescales as short as a few hundred femtoseconds. In contrast, experiments at surfaces and on single atomic layers such as graphene report timescales of structural changes that are orders of magnitude longer. This raises the question of whether the structural response of low-dimensional materials to femtosecond laser excitation is, in general, limited. Here we show that a photo-induced transition from the low- to high-symmetry state of a charge density wave in atomic indium (In) wires supported by a silicon (Si) surface takes place within 350 femtoseconds. The optical excitation breaks and creates In-In bonds, leading to the non-thermal excitation of soft phonon modes, and drives the structural transition in the limit of critically damped nuclear motion through coupling of these soft phonon modes to a manifold of surface and interface phonons that arise from the symmetry breaking at the silicon surface. This finding demonstrates that carefully tuned electronic excitations can create non-equilibrium potential energy surfaces that drive structural dynamics at interfaces in the quantum limit (that is, in a regime in which the nuclear motion is directed and deterministic). This technique could potentially be used to tune the dynamic response of a solid to optical excitation, and has widespread potential application, for example in ultrafast detectors. © 2017 Macmillan Publishers Limited, part of Springer Nature. All rights reserved.